Multi-tech-systems MULTIVOIP MVP210/410/810 Manuel d'utilisateur télécharger pdf (Page 18)

Chapter 3: Software Installation

Multi-Tech Systems, Inc. 18

7. On the next screen you can select the COM port that the command PC will use when communicating with the

MultiVOIP unit. After software installation, the COM port can be re-set in the MultiVOIP Software (from the

sidebar menu, select Connection | Settings to access the COM Port Setup screen or use keyboard shortcut

Ctrl + G).

Note: If the COM port setting made here conflicts with the actual COM port resources available in the

command PC, the “Error in Opencomm handle” message will appear when the MultiVOIP program is

launched. If this occurs, you must reset the COM port.

8. A completion screen will appear.

Figure 3-4: Completion

Click Finish.

9. When setup of the MultiVOIP software is complete, you will be prompted to run the MultiVOIP software to

configure the VOIP.

Figure 3-5: Configuration

Software installation is now complete.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 143 144

Pas de commentaire

Multi-tech-systems MULTIVOIP MVP210/410/810 Manuel d'utilisateur Page 18