Multi-tech-systems MTCBA-G-F1 Manuel d'utilisateur télécharger pdf (Page 13)

Chapter 2 – Installation

Multi-Tech Systems, Inc. MultiModem GSM/GPRS User Guide 13

Chapter 2: Installation

Mechanical Mounting

To mount the Wireless MultiModem, do the following:

1. Obtain mounting screws (two are needed) that are appropriate for the surface on which you will

mount the MultiModem. The mounting screw on the connector end of the unit must have a

screw-head no thicker than 2 mm. The allowable thickness is limited because the screw must fit

beneath the RS232 cable. The allowable thickness of the other screw-head is not limited in this

way.

= 2 mm

Screw Head

Clearance

Side View

For example, one might use two 6-32 self-tapping screws 5/8” in length to mount the unit in a

truck to the wall of the cab behind the passenger’s seat.

2. Typically, the unit is mounted against a flat surface into which holes can be drilled. The

mounting holes (center-to-center) must be separated by 125mm or 4 -15/16 inches.

Screw Separation

= 125 mm

or 4

inches

Drill the mounting holes at the desired mounting location (if applicable).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Pas de commentaire

Multi-tech-systems MTCBA-G-F1 Manuel d'utilisateur Page 13