Multi-tech-systems MT4X56USB Manuel d'utilisateur télécharger pdf (Page 55)

Chapter 5 - Remote Configuration and Management

MT4X56USB 55

Changing the Remote Escape Character

To increase security, you can change a remote modem’s remote configuration escape character. The

remote configuration escape character is stored in register S9. The factory default is 37, which is the

ASCII code for the percent character (%). Setting S9 to 0 (zero) disables remote configuration

entirely—but if you do this remotely, you won’t be able to change it back remotely!

1. Establish a remote configuration link with the remote modem as described in “Basic Procedure.”

2. Type ATS9=n, where n is the ASCII code for the new remote configuration escape character, then

press ENTER.

3. Save the new value by typing AT&W and pressing ENTER.

4. Type ATO<CR> to exit remote configuration.

Remote Configuration Commands

These commands, documented in Chapter 4 of this manual, enable you to configure various Remote

Configuration parameters: #Sx, #S=x, and %%%AT.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 95 96

Pas de commentaire

Multi-tech-systems MT4X56USB Manuel d'utilisateur Page 55