Multi-tech-systems MTS2SA-T Manuel d'utilisateur télécharger pdf (Page 168)

Chapter 16 – SNTP Client

Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A) 168

Chapter 16 – SNTP Client

Introduction

SNTP Client is used to synchronize timekeeping among a set of distributed time servers and clients. It is

built on the IP and UDP, which provide a connectionless transport mechanism.

Features

• Supports SNTP client built on UDP (port 123) to update the local time after booting and at

periodic intervals.

• Supports to set Standard Name of Time Zone.

• Supports to set offset from UTC.

• Supports Daylight savings feature.

• Supports the configuration of Offset During Daylight Savings, Start of Daylight Savings Time,

and End of Daylight Savings Time.

Command to Enable/Disable SNTP Client

The host/serial device can the use the command below to enable/disable the SNTP client.

# set sntp-client <enable/disable>

Prerequisites

Mandatory Prerequisites: The following details are mandatory configuration and have to be

validated before starting SNTP client:

• Set NTP server name or IP address.

# set sntp-client ntp-server-name <ipaddress>

• Set the time-zone (Default is UTC).

# set sntp-client time-zone <UTC>

• Set the time zone offset to be added

# set sntp-client time-zone-offset <+00:00>

• Set the polling time.

# set sntp-client polling-time <300>

ERROR Message

The send-mail command prompts for the ERROR message if any of the above details are not

configured or not valid.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 180 181

Pas de commentaire

Multi-tech-systems MTS2SA-T Manuel d'utilisateur Page 168