Multi-Tech Systems MTCBA-C-EN-NX Manuel d'utilisateur télécharger pdf (Page 39)

Chapter 3 – Using the Web Management Software

Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F) 39

3. On the Packet Filters > DNAT Configuration screen, define the DNAT rule.

Source – Select the original target network/host of the IP packets that you now want rerouted.

The original target network/host is the one previously defined in the Network

Configuration section.

Example: Any

Pre DNAT Service – Select the service for the Pre-DNAT destination. This service was just

defined in the Service Configuration section.

Example: MeterPort

Post DNAT IP – Select the destination to which the IP packets are to be diverted. Only one host

can be defined as the Post DNAT destination.

Example: MeterIP

Post DNAT Service – Select the service for the Post DNAT configuration.

Example: MeterPort

Internal Source – Select the source address for packets that going to be sent. If you do not want

to change the address, select NOCHANGE.

Example: NOCHANGE

4. Save – Click the Save button to save this configuration. Note: You must click Save and Restart once

you have completed and submitted all the screens on which you have made changes. The

device will save all the settings and reboot the PC.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 59 60

Pas de commentaire

Multi-Tech Systems MTCBA-C-EN-NX Manuel d'utilisateur Page 39