Multi-tech-systems MVP400 Manuel d'utilisateur télécharger pdf (Page 48)

MultiVOIP Quick Start Guide

parameters, and regional telephone parameters for each

channel.

Configure each channel for the type of interface you are

using. Channel 1 displays by default on the Interface tab.

To change the channel number, select the channel you

want to configure from the Select Channel list.

Feature options are enabled or unavailable according to

the interface type that you select. The Inter Digit Time

check box is available for all interface types. This option

defines the maximum amount of time that the unit will wait

before mapping the dialed digits to an entry in the Phone

Directory Database. If too much time elapses between

digits, and the wrong numbers are mapped, you will hear a

rapid busy signal. If this happens, it will be necessary to

hang up and dial again. The default is 2 seconds.

6. The Interface group defaults to FXS (Loop Start). Select

the interface option that corresponds to the interface type

being connected to the Voice/Fax Channel 1 jack on the

back panel of the MultiVOIP 400/800.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 63 64

Pas de commentaire

Multi-tech-systems MVP400 Manuel d'utilisateur Page 48