Multi-tech-systems MT5600ZDX Manuel d'utilisateur télécharger pdf (Page 32)

Model MT5600ZDX

Command: &Jn Telephone Jack Control

Values: n = 0 or 1

Default: None

Description: &J0 NA

&J1 NA

*This command is only included for compatibility and performs no

function except to load the S-Register. The parameter value, if valid, is

written S21 bit 1.

Command: &Kn Flow Control Selection

Values: n = 0, 3, 4, 5 or 6

Defaults: 3

Description: &K0 Flow control disabled.

&K3 Enable CTS/RTS hardware flow control.

&K4 Enable XON/XOFF flow control.

&K5 Enable transparent XON/XOFF flow control.

&K6 Enable both RTS/CTS and XON/XOFF flow control.

(Default for fax and voice modes.)

Command: &Ln Leased Line Operation

Values: n = 0

Defaults: None

Description: &L0 NA

*This command requests leased line or dial-up operation. This command

is provided for compatibility only; no mode change is performed, dial-up

operation continues. The OK response is returned for a valid parameter, but

no other action is performed. The parameter value, if valid, is written to

S27 bit 2.

Command: &Mn Communications Mode

Values: n = 0

Defaults: 0

Description: &M0 Asynchronous mode.

&M1 Reservedresponds ERROR.

*&M0 selects direct asynchronous operation. Note that the command

sequence &M0\N0 selects normal buffered mode, but the command

sequence \N0&M0 selects direct mode. This is because the \N0 command

is analogous to the &Q6 command.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 83 84

Pas de commentaire

Multi-tech-systems MT5600ZDX Manuel d'utilisateur Page 32